Flip and Fold Gift Card Holder

I saw a sample of this card shared online from Stampin Scrapper and wanted to give it a go.

The template uses a normal size card base with a few simple cuts. I always re-construct cards into Australian Sized cardbases and truth be told in most cases it is not that difficult. However, this card had me stumped.

Our card bases are taller and skinnier than the US sized card base and I destroyed 7 cardbases before mastering something that will work. My flap bit is a lot larger than the sample I was following but it’s the best I could do.

In the back of the front of the card there is a slot to hold a gift card. I went with the Cocktails stamps from this set as the place where I get my nails done is a Nail Cocktail Bar and I’m using these cards as samples to try and see if they will fit in with the venue to accompany their gift cards.

You can check out my video here for all the measurements

Hope you enjoyed the cards.

Once again, thank you for visiting my blog today & that you have found inspiration to create your own project.

Catalogue

If you would like a catalogue please let me know and I will pop one in the post for you.

Ordering

If you are interested in any of the products used and do not already have a Stampin’ Up! Demonstrator I would be happy to help you place an order, or you can click on the product links below which will take you directly to my online store.

Product List

Leave a Reply

Your email address will not be published. Required fields are marked *